How To Fix A Wite Out Tape Dispenser

It rotates 90 degrees right then tape it to the bottom of the spindle so it coils up as the 2 part.

How to fix a wite out tape dispenser. Place the dispenser face up in front of you. From the button open the case of the correcting tape. Cut off those used parts from the place near the small gear. Add a comment. Keep upright to prevent the fresh tape roll from falling out.

Separate two halves of wite out by prying the halves apart with your fingernails fingers coin flat blade screwdriver starting at the fat end of the wite out. Carefully remove the tape from the white guide unit. Set the plastic white out tape dispenser on a flat surface like a table or a desk. Route the clear backing tape bottom to top from the front of the white plastic tip applicator. Cut from the middle of the extra correcting tape and remove those used parts.

Remove the white guide unit from the case. Add comment cancel. Work on a clean surface so the tape doesn t stick to anything. Carefully open the case along the seam. Step 1 how to fix a correcting tape.

Keep it face up so the logo is facing you and the tape side is facing down. Add a comment.