How To Fix Water Hammer In My Shower

Turn the faucet on and run the water to flush the air out.

How to fix water hammer in my shower. If there is a wooden beam nearby you can strap the supply lines down. Occurs when water has been turned off or not in use over time. Some easy ways to fix this problem along with a couple of useful devices if you are at your wits end. To fix the issue homeowners need to drain their plumbing system. You may temporarily relieve water hammer by using the shower faucet s access panel on the wall directly behind the faucet to access the water valves.

Locate the main valve of your water line and shut it off. Take note of anywhere you might be able to add pipe straps or insulation to stabilize the supply lines. If you would like a shock arrester as in the video he. Make sure that water is also flushed from the toilet before turning the water supply on again to your house. Shut off the main water valve open the highest faucet in your home and drain water from the lowest faucet usually in the.

Next turn all faucets you could find around the house on. After a few minutes of flushing air turn the faucet off for 5 minutes. Water hammer occurs when the water in the pipes does not flow smoothly because of the presence of air in the pipes causing them to move or make knocking noises. Drain water from all open faucets and wait for 30 minutes. You can identify where the water hammer is happening by listening for where the banging is loudest.

It s also advisable to start with the highest water outlet in your house till you reach the lowest point. Connect the supply tube or hoses connect the water supply tube or hose to each water hammer arrestor and tighten the connection with pliers or a wrench.